On Tue, 2006-06-06 at 21:31 +0200, Kai Schaetzl wrote:
William L. Maltby wrote on Tue, 06 Jun 2006 12:40:29 -0400:
do* remember this being discussed several times on the list
Yeah, and I followed them all with interest and read the referenced how-tos. That's why I think I did all correct, but still it doesn't work. Mostly, it bothers me that the installation of grub to both disks seems to work but nothing changes.
it was always make boot partitions on each drive and install grub, test that both are bootable, install all else, "kill" a drive and test again.
I setup the RAID mirror during initial installation, then installed grub to both disks following a how-to and then tested. The problem is that installing grub doesn't change anything on none of the drives it seems. I did it now several times and there is no change. The first one is "grub grub grub"ing and the second puts me in the grub prompt and boots only "manually".
I can't be much help at all unless my background (several years back - memory may have aged out and been permanently "swapped") using LILO for some stuff might give clues.
I continue only in the hope that the answer might come to you while awaiting knowledgeable participation.
Is it correct that the raid must come into play after initial boot *if* one is to be able to boot on the remaining disk after primary fails?
My thinking is that if raid is in play when grub is installed, does it mess up where things are put? If not, does it mess up when there's a failure (raid 0,....5... I guess would affect that).
Is it boot from boot partition, install grub, copy to second disk. Is grub (stage 1?) installed in *partition* or in mbr? If in partition, partition must be made active? Both drives?
If raid is active when you try to write initial loader to mbr/partition, does it mess it up?
Can you get to where you can boot one disk w/o raid active? It would be aggravating if it was nothing raid related, but some hardware/user/software error making you think it was your raid doing it to you.
Kai
HTH