At 10:57 PM 1/25/2006, Craig White wrote:
On Wed, 2006-01-25 at 22:22 -0500, Robert Moskowitz wrote:
Here is the output of that lapci command. You will see that the first ethernet and last Tiger Jet are both on IRQ5.
Is this controlled/controllable via some config file?
might be a DOS utility available to switch the settings...depends upon the hardware. I think it is acceptable to share IRQ's on some devices though...we are out of my league now.
Learned a little at:
http://www.scyld.com/pci_irq.html
So I found that I have:
cat interrupts CPU0 0: 103391 XT-PIC timer 1: 3 XT-PIC i8042 2: 0 XT-PIC cascade 5: 68774 XT-PIC wcfxo, eth0 8: 1 XT-PIC rtc 9: 0 XT-PIC acpi 10: 0 XT-PIC Intel 82801BA-ICH2 11: 68594 XT-PIC uhci_hcd, wcfxo 12: 66 XT-PIC i8042 14: 4174 XT-PIC ide0 15: 893 XT-PIC ide1 NMI: 0 ERR: 0
I turned off the internal serials on 3&4 and the Parallel on 7, buy the BIOS only allows me 5,10,&11 for these PCI devices :(
One ethernet and one FXO share 5, and the USB and the other FXO share 11
Since these are serial devices I am going to ASSUME that they will be serviced well enough.
Since I am not using my USB, I will put my main subnet on the internal ethernet and main phone on the one using irq11...