Sorry, just a follow up to see if anyone has similar experiences with the method of kickstarting bridges on CentOS 7.1. According to the docs things are correct for 7.1 and I just want to make sure I'm not doing something incorrectly before filing a bug with Red Hat
----- Original Message ----- | Hello All, | | I seem to have run into a bug with the new --bridgeslaves=<INTERFACE> option. | It would seem that if I tell the bridge device to use a virtual interface | (like bond0) rather than a physical interface (em1/em2) that kickstart | completely barfs on it. I have provided my network section below which | works fine as long as i don't enable all the bridge content. | | When the installation starts off the creation of bond0 and all VLANs on bond0 | go without issue. Jumping into TTY2 I can type 'ip a' and see all the bond0 | device and bond0.VLANID devices no problem. | | When I enable bridge content with --bridgeslaves=bond0 or | --bridgeslaves=bond0.VLANID anaconda barfs | | When I enable bridge content with --bridgeslaves=em1 or --bridgeslaves=em2 | anaconda doesn't have an issue. | | Is this expected behaviour? I really don't want to have to manually | manipulate the ifcfg-bond* interfaces and create the ifcfg-BRIDGE* | interfaces manually so I'd like this to work. | | | | | # Configure a bond over the slaves in failover mode | network --device=bond0 --noipv6 --bootproto=dhcp --onboot=yes | --bondslaves=em1,em2 --bondopts=mode=active-backup;primary=em1 --activate | | # Configure VLANs | network --device=bond0 --vlanid=11 --noipv6 --onboot=yes --bootproto=dhcp | --activate | network --device=bond0 --vlanid=100 --noipv6 --onboot=yes --bootproto=dhcp | --activate | network --device=bond0 --vlanid=302 --noipv6 --onboot=yes --bootproto=dhcp | --activate | network --device=bond0 --vlanid=303 --noipv6 --onboot=yes --bootproto=dhcp | --activate | network --device=bond0 --vlanid=304 --noipv6 --onboot=yes --bootproto=dhcp | --activate | network --device=bond0 --vlanid=306 --noipv6 --onboot=yes --bootproto=dhcp | --activate | | # Create a bridge on the bonded VLAN interfaces | network --device=FASNET --bridgeslaves=bond0 | network --device=GLUSTER --bridgeslaves=bond0.11 | network --device=EXPERIMENTAL --bridgeslaves=bond0.302 | network --device=NAT --bridgeslaves=bond0.303 | network --device=DMZ2 --bridgeslaves=bond0.304 | network --device=NETM --bridgeslaves=bond0.306 | | -- | James A. Peltier | IT Services - Research Computing Group | Simon Fraser University - Burnaby Campus | Phone : 604-365-6432 | Fax : 778-782-3045 | E-Mail : jpeltier@sfu.ca | Website : http://www.sfu.ca/itservices | Twitter : @sfu_rcg | Powering Engagement Through Technology | _______________________________________________ | CentOS mailing list | CentOS@centos.org | http://lists.centos.org/mailman/listinfo/centos |