Re: [CentOS] Installing CentOS 5.4 64bit on server with LSI SAS 1068E controller.

On Fri, 2009-11-27 at 22:10 -0500, Billy Huddleston wrote:

I just read the user manual on it.. It says the following...

IT Mode (Initiator and Target Mode) This is a Non-RAID mode. To use this mode, be sure to fl ash an IT mode firmware to the EEPROM and to install an IT Mode driver to the system OS.

So, I'm confused, what point is a RAID controller that doesn't support RAID ?

Thanks, Billy

Probably for compliance, might as well give it a try if you can...

The Perc 4i/5i stuff that Steve was talking about is definitely supported as I have a server that uses this. They may be exposed and use different drivers than the straight LSI SAS 1068E.

Steve: What module does your Dell Perc use? I don't have access to my server to check.