I have seen those documents, I did not see anything that indicates how _automatic_ bridge configuration could be enabled with xl.  

For my specific set up I have two bridges (xenbr0 -> peth0 & xenbr1 -> peth1).  If I have to configure this manually with ifcfg scripts I will, but if an automatic method is provided or is possible with xl I'd prefer to use that.

-Gene 

On Thu, Jan 29, 2015 at 4:07 AM, Lars Kurth <lars.kurth.xen@gmail.com> wrote:
Gene,
I think you should find the answers in
* http://wiki.centos.org/HowTos/Xen/Xen4QuickStart/Xen4Libvirt (bottom of page)
* http://wiki.xenproject.org/wiki/Migration_Guide_To_Xen4.1%2B
* http://wiki.xenproject.org/wiki/Network_Configuration_Examples_%28Xen_4.1%2B%29
* http://wiki.xenproject.org/wiki/XL_vs_Xend_Feature_Comparison may also be relevant
If not, circle back to the list and I am sure someone else will be able to answer
Regards
Lars

On 29 Jan 2015, at 08:39, Gene <gh5046@gmail.com> wrote:

I normally use the network-script parameter in the '/etc/xen/xend-config.sxp' configuration file to configure network bridges.  However, the latest release of Xen4CentOS (which comes with Xen 4.4.1) has xend disabled by default.  

Can I continue to use network-script without xend?  If not what is the recommended method for automatically configuring network bridges with the latest release of Xen4CentOS?

I know I can just enable xend to continue using this script, but since Xen 4.5 is apparently dropping xend altogether I figure I should change my standard configuration starting now.

Thanks in advance for your time.

-Gene

_______________________________________________
CentOS-virt mailing list
CentOS-virt@centos.org
http://lists.centos.org/mailman/listinfo/centos-virt


_______________________________________________
CentOS-virt mailing list
CentOS-virt@centos.org
http://lists.centos.org/mailman/listinfo/centos-virt