On 12/28/2015 08:34 PM, Robert Moskowitz wrote: > > > On 12/28/2015 08:28 PM, Dave Germiquet wrote: >> Hello, >> >> I am looking into putting Centos on my Beaglebone Black, and I came >> across your rootfs factory. I'm wondering how it works and what is >> the high->low level of implementing. >> >> Do I need an existing arm binary system? >> >> Currently Beaglebone black comes with debian, and my desktop is >> debian, how would I use your scripts, to make the initial image? >> >> The end goal is to have a centos system with Selinux enabled. > > RIght now we do not have a general image with all the uboots on it. > But do not fear, we will get you going... > > You will dd the Cubietruck image onto a mSD card. From: > > http://mirror.centos.org/altarch/7/isos/armhfp/ > > I will get the Beaglebone black uboot, put it up on my server, and > tell you how to dd that uboot onto the mSD card and then you should be > good to boot... OK. Look over at: http://medon.htt-consult.com/~rgm/beaglebone/ To put these on your mSD card you would do: sudo dd if=MLO of=$MEDIA count=1 seek=1 conv=notrunc bs=128k; sync sudo dd if=u-boot.img of=$MEDIA count=2 seek=1 conv=notrunc bs=384k; sync where $MEDIA is /dev/<where your card is> I THINK this will work. There was quite a thread on the BBB on the Fedora-arm list back in the summer... -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/arm-dev/attachments/20151228/ea7b2fa9/attachment-0006.html>