Do you have selinux-policy and selinux-policy-targeted packages installed? On Fri, Dec 23, 2016 at 2:58 PM, Fabian Arrotin <arrfab at centos.org> wrote: > On 23/12/16 02:49, Robert Moskowitz wrote: > > This is on a Cubieboard2 with the OS on a sata HD: > > > > I followed the instructions on the wiki > > > > vi /etc/sysconfig/selinux <- change from "permissive" to "enforcing" > > vi /boot/extlinux/extlinux.conf <- change the "enforce=0" to "enforce=1" > > touch /.autorelabel > > > > I then rebooted and the following appears on the console log: > > > > [ OK ] Reached target Switch Root. > > Starting Switch Root... > > [ 10.682159] systemd-journald[129]: Received SIGTERM from PID 1 > > (systemd). > > [ 11.306507] systemd[1]: Failed to load SELinux policy. > > [!!!!!!] Failed to load SELinux policy, freezing. > > > > > > Note that /boot is sda1 and / is sda3 > > > > I am awaiting guidance. > > > > thank you > > > > Hmm, the way I do it is : > - ensure enforce=1 in extlinux.conf (but keep /etc/sysconfig/selinux to > permissive) > - touch /.autorelabel && systemc reboot > > Than wait and when it's finally online, "setenforce 1" and then > /etc/sysconfig/selinux to enforcing > > -- > Fabian Arrotin > The CentOS Project | http://www.centos.org > gpg key: 56BEC54E | twitter: @arrfab > > > _______________________________________________ > Arm-dev mailing list > Arm-dev at centos.org > https://lists.centos.org/mailman/listinfo/arm-dev > > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/arm-dev/attachments/20161223/6b21bdd7/attachment-0006.html>