[Arm-dev] Gigabyte MP30-AR0

Sat Feb 20 16:15:32 UTC 2016
Michael Howard <mike at dewberryfields.co.uk>

Hi,

I've just subscribe to the list to contribute to this thread.

I tried the instructions at 
https://lists.centos.org/pipermail/arm-dev/2016-February/001623.html 
without success. The session below appears to result in the board hanging;

[START SESSION]

Hit any key to stop autoboot:  0
MP30AR0# setenv num_cores 1
MP30AR0# setenv load_tianocore 'tftp 0x4002000000 
mp30/mp30ar0_tianocore_ubt.fd;
tftp 0x1d000000 mp30/mp30ar0_tianocore_sec_ubt.fd'
MP30AR0# setenv run_tianocore 'go 0x1d000000'
MP30AR0# run load_tianocore run_tianocore
Port0 is down
Using eth0 device
TFTP from server 192.168.1.12; our IP address is 192.168.1.120
Filename 'mp30/mp30ar0_tianocore_ubt.fd'.
Load address: 0x4002000000
Loading: #################################################################
#############################################################
          3.2 MiB/s
done
Bytes transferred = 1835008 (1c0000 hex)
Using eth0 device
TFTP from server 192.168.1.12; our IP address is 192.168.1.120
Filename 'mp30/mp30ar0_tianocore_sec_ubt.fd'.
Load address: 0x1d000000
Loading: ##################
          2.9 MiB/s
done
Bytes transferred = 262144 (40000 hex)
## Starting application at 0x1D000000 ...


X-Gene Mp30ar0 Board
Boot firmware (version 1.20.03 built at 18:22:28 on Jan 26 2016)

[END SESSION]

Nothing appears on either the serial or vga after this. For completeness 
I also did a 'reset' after 'setenv num_cores 1' though I didn't get the 
point. The result is exactly the same.

Any other pointers greatly appreciated.

-- 
Mike Howard