Thanks, Mike. I never used the graphical installer before, but adding ip=dhcp to the grub command line does the trick then. -Phong -----Original Message----- From: arm-dev-bounces at centos.org [mailto:arm-dev-bounces at centos.org] On Behalf Of Michael Howard Sent: Tuesday, February 23, 2016 7:15 PM To: arm-dev at centos.org Subject: Re: [Arm-dev] Gigabyte MP30-AR0 On 23/02/2016 11:58, Phong Vo wrote: > I see that CentOS installer somehow does not detect network, so it gives > text-based installation. > However, once installation is finished, check your > /etc/sysconfig/network-scripts/ifcfg-eth0 > (or something similar). > > Make sure > BOOTPROTO=dhcp > ONBOOT=y > > Change ONBOOT to y and reboot should get network working. > > Hi, Yes, I did that but it was still no go. The problem with the installed system was that I hadn't set the hardware address in UEFI (set MAC0 xx:xx:xx:xx:xx:xx), after that networking worked. The installer still didn't detect a connection on any of the nics, though I could assign an ip manually at the shell. Editing grub command line before running the installer cured that issue. Cheers, -- Mike Howard _______________________________________________ Arm-dev mailing list Arm-dev at centos.org https://lists.centos.org/mailman/listinfo/arm-dev