[Arm-dev] Gigabyte MP30-AR0

[Michael Howard]

On 05/03/2016 11:06, Richard W.M. Jones wrote:
> On Sat, Mar 05, 2016 at 10:26:25AM +0700, Phong Vo wrote:
>> There should be no issue of replacing U-boot in SPI nor with the mp30ar0
>> Tianocore version.
>> But you need to use the mp30ar0_tianocore_media.img I provide, not the one
>> supplied
>> with the Mustang board. It was likely the person burn the wrong BIOS on
>> the board!
>>
>> You can burn the Tianocore image from U-boot using TFTP. Please check and
>> setup your U-boot
>> variables:
>>
>> media_addr_r=0x4001000000
>> media_img=mp30ar0_tianocore_media.img
>> spi_load=tftp ${media_addr_r} ${user_dir}/${media_img}
>> spi_update=sf probe 0; sf erase 0x0 ${filesize}; sf write ${media_addr_r}
>> 0x0 ${filesize}
>>
>> # run spi_load   <== Make sure it is successful
>> # run spi_update
>> # reset
>>
>> If there is any issue, it's still recoverable using SD card.
> As a warning to anyone else, that bricked mine.
>
Since your post yesterday? Did u-boot chainload UEFI ok prior to 
attempting the permanent change?

-- 
Mike Howard