[Arm-dev] Gigabyte MP30-AR0

[Michael Howard]

On 12/03/2016 13:07, Gordan Bobic wrote:
> On 12/03/16 12:48, Michael Howard wrote:
>> On 12/03/2016 12:36, Gordan Bobic wrote:
>>> On 12/03/16 12:04, Gordan Bobic wrote:
>>>> On 22/02/16 05:02, Phong Vo wrote:
>>>>> Hi,
>>>>>
>>>>> The mp30ar0 U-boot has some special memory mapping to accommodate
>>>>> 32-bit
>>>>> DMA.
>>>>> Please download the tar ball again - I've updated the tianocore 
>>>>> UHP for
>>>>> this.
>>>>>
>>>>> https://dl.dropboxusercontent.com/u/20403943/mp30ar0_tianocore_binaries.ta 
>>>>>
>>>>>
>>>>>
>>>>> r.xz
>>>>>
>>>>> Updated instruction for U-boot chain loading:
>>>>> MP30AR0# setenv num_cores 1
>>>>> MP30AR0# setenv DDRBASE2G 1
>>>>> MP30AR0# save; reset
>>>>
>>>> I just did this part and it seems to have semi-bricked the board. It
>>>> gets as far as:
>>>> ===
>>>> U-Boot 2013.04 (Jun 02 2015 - 10:54:10)ooREV: 1.15.01-F05 ( uart0 )
>>>> ===
>>>>
>>>> and it just stops.
>>>>
>> As mentioned in one of my other posts , check the vga output or serial
>> output if you are using vga. You have actually only changed one
>> variable, DDRBASE2G would have already been set.
>
> I checked, and DDRBASE2G wasn't defined.
>
> I don't suppose you managed to get "serial over LAN" working on the 
> BMC? Getting to the actual serial console over ILO is... as 
> unintuitive as it is undocumented...
IPMI works, that I know, I tested it by pulling sensor readings. I 
haven't tried to access the serial console directly though. I'll take a 
look.

-- 
Mike Howard