On 12/03/2016 13:07, Gordan Bobic wrote: > On 12/03/16 12:48, Michael Howard wrote: >> On 12/03/2016 12:36, Gordan Bobic wrote: >>> On 12/03/16 12:04, Gordan Bobic wrote: >>>> On 22/02/16 05:02, Phong Vo wrote: >>>>> Hi, >>>>> >>>>> The mp30ar0 U-boot has some special memory mapping to accommodate >>>>> 32-bit >>>>> DMA. >>>>> Please download the tar ball again - I've updated the tianocore >>>>> UHP for >>>>> this. >>>>> >>>>> https://dl.dropboxusercontent.com/u/20403943/mp30ar0_tianocore_binaries.ta >>>>> >>>>> >>>>> >>>>> r.xz >>>>> >>>>> Updated instruction for U-boot chain loading: >>>>> MP30AR0# setenv num_cores 1 >>>>> MP30AR0# setenv DDRBASE2G 1 >>>>> MP30AR0# save; reset >>>> >>>> I just did this part and it seems to have semi-bricked the board. It >>>> gets as far as: >>>> === >>>> U-Boot 2013.04 (Jun 02 2015 - 10:54:10)ooREV: 1.15.01-F05 ( uart0 ) >>>> === >>>> >>>> and it just stops. >>>> >> As mentioned in one of my other posts , check the vga output or serial >> output if you are using vga. You have actually only changed one >> variable, DDRBASE2G would have already been set. > > I checked, and DDRBASE2G wasn't defined. > > I don't suppose you managed to get "serial over LAN" working on the > BMC? Getting to the actual serial console over ILO is... as > unintuitive as it is undocumented... IPMI works, that I know, I tested it by pulling sensor readings. I haven't tried to access the serial console directly though. I'll take a look. -- Mike Howard