On 12/03/16 13:27, Michael Howard wrote: > > > On 12/03/2016 13:07, Gordan Bobic wrote: >> On 12/03/16 12:48, Michael Howard wrote: >>> On 12/03/2016 12:36, Gordan Bobic wrote: >>>> On 12/03/16 12:04, Gordan Bobic wrote: >>>>> On 22/02/16 05:02, Phong Vo wrote: >>>>>> Hi, >>>>>> >>>>>> The mp30ar0 U-boot has some special memory mapping to accommodate >>>>>> 32-bit >>>>>> DMA. >>>>>> Please download the tar ball again - I've updated the tianocore >>>>>> UHP for >>>>>> this. >>>>>> >>>>>> https://dl.dropboxusercontent.com/u/20403943/mp30ar0_tianocore_binaries.ta >>>>>> >>>>>> >>>>>> >>>>>> r.xz >>>>>> >>>>>> Updated instruction for U-boot chain loading: >>>>>> MP30AR0# setenv num_cores 1 >>>>>> MP30AR0# setenv DDRBASE2G 1 >>>>>> MP30AR0# save; reset >>>>> >>>>> I just did this part and it seems to have semi-bricked the board. It >>>>> gets as far as: >>>>> === >>>>> U-Boot 2013.04 (Jun 02 2015 - 10:54:10)ooREV: 1.15.01-F05 ( uart0 ) >>>>> === >>>>> >>>>> and it just stops. >>>>> >>> As mentioned in one of my other posts , check the vga output or serial >>> output if you are using vga. You have actually only changed one >>> variable, DDRBASE2G would have already been set. >> >> I checked, and DDRBASE2G wasn't defined. >> >> I don't suppose you managed to get "serial over LAN" working on the >> BMC? Getting to the actual serial console over ILO is... as >> unintuitive as it is undocumented... >> > Ok, tried SOL and that works here. I used; > > ipmitool -I lanplus -H 192.168.1.81 -U admin -P password sol activate You, sir, are awesome. :) Not to mention right - for some reason u-boot did indeed decide to go to serial only with no VGA. What setting is used to control that? Gordan