[Arm-dev] Making an image
Robert Moskowitz
rgm at htt-consult.com
Thu Mar 2 22:39:32 UTC 2017
I looked at output from writing the image:
sudo dd of=/dev/sdb bs=4M; sync
0+346813 records in
0+346813 records out
3221225472 bytes (3.2 GB, 3.0 GiB) copied, 147.907 s, 21.8 MB/s
Would this be what I want:
dd if=/dev/sdb of=cubietruck.img bs=4M count=346813
On 03/02/2017 04:33 PM, Robert Moskowitz wrote:
> Can I have a little help making an image via dd, and then compressing it?
>
> I want to save 'checkpoints' of my build process, so that when I have
> to go back, I do not have to go all the way back to the base image.
>
> I have built my basic image (I will be updating my howto, found a few
> bugs), and fdisk reports:
>
> Disk /dev/sda: 120.0 GB, 120034124288 bytes, 234441649 sectors
> Units = sectors of 1 * 512 = 512 bytes
> Sector size (logical/physical): 512 bytes / 512 bytes
> I/O size (minimum/optimal): 512 bytes / 512 bytes
> Disk label type: dos
> Disk identifier: 0x0000c89d
>
> Device Boot Start End Blocks Id System
> /dev/sda1 2048 1026047 512000 83 Linux
> /dev/sda2 1026048 2074623 524288 82 Linux swap /
> Solaris
> /dev/sda3 2074624 6268927 2097152 83 Linux
>
> Obviously, I do not want to dd the whole 120GB, as I am still only
> using 4GB, though I will probably have to enlarge sda3 a bit to hold
> all the software I need. I did this a couple years back, but can't
> find my notes. :(
>
> thanks
>
> _______________________________________________
> Arm-dev mailing list
> Arm-dev at centos.org
> https://lists.centos.org/mailman/listinfo/arm-dev
>
More information about the Arm-dev
mailing list