[Arm-dev] Security Audit service failing

[Robert Moskowitz]

Gone away?

Just did a power cycle and this time there was no service failing. 
Needed something in an initial reboot?

Strange.

On 08/06/2018 03:32 PM, Robert Moskowitz wrote:
> This is on a Cubieboard2
>
> I took the CentOS-Userland-7-armv7hl-generic-Minimal-1804-sda image, did
>
> yum install policycoreutils-python
> passwd
> hostnamectl set-hostname nevia.htt-consult.com
> adduser -c "Robert Moskowitz" -G wheel rgm
> passwd rgm
> timedatectl set-timezone America/Detroit
> vi /etc/ssh/sshd_config  # change port number
>
> semanage port -a -t ssh_port_t -p tcp nnn
> systemctl restart sshd.service
> firewall-cmd --permanent --add-port=nnn/tcp
> firewall-cmd --permanent --remove-service=ssh
> firewall-cmd --reload
>
> Yum update
>
> poweroff
>
> power on, and on the console see messages:
>
> [  OK  ] Started Tell Plymouth To Write Out Runtime Data.
> [  OK  ] Started Import network configuration from initramfs.
>          Starting Create Volatile Files and Directories...
> [  OK  ] Started Create Volatile Files and Directories.
>          Starting Security Auditing Service...
> [ ***  ] A start job is running for Security...ting Service (3min 3s / 
> 3min 8s)
>
> Then it takes off.  I could scan the console capture if you need the 
> messages immediately after it finally took off.  But I have noticed 
> this service failing to start on one of my other boxes, not not on the 
> other two.  So it revolves around something installed or not installed.
>
> But with this base of an install, perhaps you can figure out what the 
> problem is?
>
> thanks
>
> _______________________________________________
> Arm-dev mailing list
> Arm-dev at centos.org
> https://lists.centos.org/mailman/listinfo/arm-dev