-----Oorspronkelijk bericht----- > Afzender:Robert Moskowitz <rgm at htt-consult.com> > Verstuurd: Zondag 9 December 2018 23:45 > Aan: Conversations around CentOS on ARM hardware <arm-dev at centos.org>; Pablo Sebastián Greco <pablo at fliagreco.com.ar> > Onderwerp: Re: [Arm-dev] Instructions for installation on an Odroid HC1 > > > > On 12/9/18 3:45 PM, Pablo Sebastián Greco wrote: > > <snip> > >>> Thanks! Getting it now.... > >> > >> Looks like the same dracut failure. > >> > >> :( > >> > >> > > There must be another module missing, can you decompress the fedora > > initramfs and list the used modules? For the odroid HC1 i added textra drivers as sown below in /etc/dracut.conf.d/odroid_hc1.conf add_dracutmodules+=" dm " omit_dracutmodules+=" network ifcfg plymouth " add_drivers+=" exynosdrm exynos_bus exynos_trng exynos_nocp exynos_rng phy_exynos_dp_video " add_drivers+=" phy_exynos_mipi_video dwc3_exynos clk_exynos_audss i2c_exynos5 dw_mmc_exynos " add_drivers+=" dw_mmc_pltfm dw_mmc phy_exynos_usb2 phy_exynos5_usbdrd pwm_samsung " add_drivers+=" dwc3 ledtrig-heartbeat " also see: https://lists.centos.org/pipermail/arm-dev/2018-October/003578.html and https://gist.github.com/markVnl/7adf25cebfdce5d5009d93b7b4caae96 Hope it helps > > > > You may need to use this command in an empty dir > > > > /usr/lib/dracut/skipcpio $your-img | gunzip -c | cpio -id > > > I will get it to you. Don't know if it will be today, anymore... > > Robert > > _______________________________________________ > Arm-dev mailing list > Arm-dev at centos.org > https://lists.centos.org/mailman/listinfo/arm-dev >