[CentOS-de] CentOS 6.x bonding RX errors
Sven Knohsalla
s.knohsalla at netbiscuits.com
Di Aug 27 08:30:18 UTC 2013
Hi,
leider habe ich keine Lösung zu meinem Problem im Netz finden können:
bonding (mode unabhängig) löst RX errors aus.
Dies geschieht erst seit einer neueren Kernel Version,
leider kann ich die letztfunktionierende Version nicht mehr einsehen.
Einen Workaround im Netz habe ich zu ähnlichen Themen finden können:
modprobe bnx2 disable_msi=1 && service network restart
Jedoch zeigte dies keine Wirkung auf unseren Systemen: Dell PE 1950 III
Hardware wurde bereits komplett gegen äquivalente Komponente getauscht, ohne Wirkung.
Das Problem tritt erst unter Verwendung des bonding stacks auf und kann auch mit einem kernel > 3.x nicht behoben werden.
Es muss mit dem bnx2 Modul zu tun haben.
Vielen Dank vorab für Ratschläge & Hilfe!
System Informationen:
[root at KVM-INT-01 ~]# uname -a
Linux KVM-INT-01 2.6.32-220.23.1.el6.x86_64 #1 SMP Mon Jun 18 18:58:52 BST 2012 x86_64 x86_64 x86_64 GNU/Linux
[root at KVM-INT-01 ~]# cat /etc/issue
CentOS release 6.4 (Final)
Kernel \r on an \m
[root at KVM-INT-01 ~]# dmesg | grep bnx
bnx2: Broadcom NetXtreme II Gigabit Ethernet Driver bnx2 v2.1.11 (July 20, 2011)
bnx2 0000:03:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
bnx2 0000:03:00.0: firmware: requesting bnx2/bnx2-mips-06-6.2.1.fw
bnx2 0000:03:00.0: firmware: requesting bnx2/bnx2-rv2p-06-6.0.15.fw
bnx2 0000:03:00.0: eth0: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit 133MHz found at mem f8000000, IRQ 16, node addr 00:1e:c9:b7:c3:44
bnx2 0000:07:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
bnx2 0000:07:00.0: firmware: requesting bnx2/bnx2-mips-06-6.2.1.fw
bnx2 0000:07:00.0: firmware: requesting bnx2/bnx2-rv2p-06-6.0.15.fw
bnx2 0000:07:00.0: eth1: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit 133MHz found at mem f4000000, IRQ 16, node addr 00:1e:c9:b7:c3:46
bnx2 0000:03:00.0: irq 31 for MSI/MSI-X
bnx2 0000:03:00.0: eth0: using MSI
bnx2 0000:07:00.0: irq 32 for MSI/MSI-X
bnx2 0000:07:00.0: eth1: using MSI
bnx2 0000:03:00.0: eth0: NIC Copper Link is Up, 1000 Mbps full duplex
Broadcom NetXtreme II iSCSI Driver bnx2i v2.7.0.3 (Jun 15, 2010)
iscsi: registered transport (bnx2i)
bnx2 0000:03:00.0: irq 31 for MSI/MSI-X
bnx2 0000:03:00.0: eth0: using MSI
bnx2 0000:07:00.0: irq 32 for MSI/MSI-X
bnx2 0000:07:00.0: eth1: using MSI
bnx2 0000:03:00.0: eth0: NIC Copper Link is Up, 1000 Mbps full duplex
[root at KVM-INT-01 ~]# cat /etc/sysconfig/network-scripts/ifcfg-eth1
DEVICE=eth1
ONBOOT=yes
USERCTL=no
MASTER=bond0
SLAVE=yes
BOOTPROTO=no
[root at KVM-INT-01 ~]# cat /etc/sysconfig/network-scripts/ifcfg-eth0
DEVICE=eth0
ONBOOT=yes
USERCTL=no
MASTER=bond0
SLAVE=yes
BOOTPROTO=no
#BRIDGE=br0
[root at KVM-INT-01 ~]# cat /etc/sysconfig/network-scripts/ifcfg-bond0
DEVICE=bond0
BOOTPROTO=static
NM_CONTROLLED=no
ONBOOT=yes
BRIDGE=br0
[root at KVM-INT-01 ~]# cat /etc/sysconfig/network-scripts/ifcfg-bond0.90
VLAN=yes
DEVICE=bond0.90
#DEVICE=eth0.90
BOOTPROTO=static
NM_CONTROLLED=no
ONBOOT=yes
BRIDGE=br0.90
[root at KVM-INT-01 ~]# cat /etc/sysconfig/network-scripts/ifcfg-br0
DEVICE=br0
BOOTPROTO=static
IPADDR=IP
NETMASK=255.255.255.0
NM_CONTROLLED=no
ONBOOT=yes
TYPE=Bridge
[root at KVM-INT-01 ~]# cat /etc/sysconfig/network-scripts/ifcfg-br0.90
DEVICE=br0.90
BOOTPROTO=static
IPADDR=IP
NETMASK=255.255.255.0
GATEWAY=IP
DNS=IP
NM_CONTROLLED=no
ONBOOT=yes
TYPE=Bridge
[root at KVM-INT-01 ~]# cat /proc/cpuinfo | grep model
model : 15
model name : Intel(R) Xeon(R) CPU E5320 @ 1.86GHz
[root at KVM-INT-01 ~]# cat /proc/net/dev | grep bond0
bond0:4314313224 8066220 13001 0 0 13001 0 65234 6009460614 8721696 0 0 0 0 0 0
bond0.90: 8841809 127731 0 0 0 0 0 34037 23483111 88193 0 0 0 0 0 0
[root at KVM-INT-01 ~]# ifconfig bond0
bond0 Link encap:Ethernet HWaddr 00:1E:C9:B7:C3:44
UP BROADCAST RUNNING PROMISC MASTER MULTICAST MTU:1500 Metric:1
RX packets:8084734 errors:13025 dropped:0 overruns:0 frame:13025
TX packets:8741436 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4324288392 (4.0 GiB) TX bytes:6022732119 (5.6 GiB)
[root at KVM-INT-01 ~]# ifconfig bond0.90
bond0.90 Link encap:Ethernet HWaddr 00:1E:C9:B7:C3:44
UP BROADCAST RUNNING MASTER MULTICAST MTU:1500 Metric:1
RX packets:128054 errors:0 dropped:0 overruns:0 frame:0
TX packets:88400 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:8861844 (8.4 MiB) TX bytes:23498293 (22.4 MiB)
[root at KVM-INT-01 ~]# cat /etc/modprobe.d/bonding.conf
alias bond0 bonding
options bonding miimon=100 mode=1
alias bond0.90 bonding
options bonding miimon=100 mode=1
[root at KVM-INT-01 ~]# lsmod | grep bnx
bnx2i 45110 0
cnic 53443 1 bnx2i
libiscsi 47521 8 be2iscsi,bnx2i,cxgb4i,cxgb3i,libcxgbi,ib_iser,iscsi_tcp,libiscsi_tcp
scsi_transport_iscsi 48010 8 be2iscsi,bnx2i,libcxgbi,ib_iser,iscsi_tcp,libiscsi
bnx2 79618 0
Mit freundlichem Gruß,
Sven Knohsalla | System Administration
Office +49 631 68036 433 | Fax +49 631 68036 111 |E-Mail s.knohsalla at netbiscuits.com | Skype: netbiscuits.admin
Netbiscuits GmbH | Europaallee 10 | 67657 | GERMANY
[https://my.netbiscuits.com/image/image_gallery?uuid=3a1a9d19-c305-4032-8cef-00b03c3d4c79&groupId=10211&t=1361534926402]<http://www.netbiscuits.com/>
[https://my.netbiscuits.com/image/image_gallery?uuid=9e553e7b-3e7d-4784-b274-15aa1dfb48e2&groupId=10211&t=1361533377340] <https://www.netbiscuits.com/news> [https://my.netbiscuits.com/image/image_gallery?uuid=1d1a5e29-ceda-4ab1-9353-67a1e838364d&groupId=10211&t=1347281040591] <https://twitter.com/netbiscuits> [https://my.netbiscuits.com/image/image_gallery?uuid=c99bf866-be25-4236-a0ee-dca68ec828a5&groupId=10211&t=1347280983848] <http://www.linkedin.com/company/netbiscuits> [https://my.netbiscuits.com/image/image_gallery?uuid=d62ba951-14dc-450d-b5f1-be33884225e3&groupId=10211&t=1347280983872] <http://www.xing.com/companies/netbiscuitsgmbh> [https://my.netbiscuits.com/image/image_gallery?uuid=7b28f500-f415-40bb-851f-0cd55beeaf45&groupId=10211&t=1347280983791] <https://www.facebook.com/Netbiscuits> [https://my.netbiscuits.com/image/image_gallery?uuid=cc8764d0-a5ac-4623-bb63-da3ca7c97f94&groupId=10211&t=1347280983836] <https://plus.google.com/u/0/112410769451962733032> [https://my.netbiscuits.com/image/image_gallery?uuid=a15e871c-a11b-419c-acca-da5a0ebd5856&groupId=10211&t=1347281040599] <http://www.youtube.com/user/netbiscuits>
Register Court: Local Court Kaiserslautern | Commercial Register ID: HR B 3604
Management Board: Guido Moggert, Michael Neidhöfer, Christian Reitz, Martin Süß
This message and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. It may also be privileged or otherwise protected by work product immunity or other legal rules. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. If you are not the intended recipient you are notified that disclosing, copying, distributing or taking any action in reliance on the contents of this information is strictly prohibited.
Warning: Although Netbiscuits has taken reasonable precautions to ensure no viruses are present in this email, the company cannot accept responsibility for any loss or damage arising from the use of this email or attachments.
[http://www.netbiscuits.com/image/image_gallery?uuid=0ba7711a-a277-4ea0-acb0-17fe13c3089d&groupId=10211&t=1348560850164]Please consider the environment before printing
-------------- nächster Teil --------------
Ein Dateianhang mit HTML-Daten wurde abgetrennt...
URL: http://lists.centos.org/pipermail/centos-de/attachments/20130827/6825e35d/attachment-0001.html