Hi all, I just installed centos 5.4 xen-kernel on intel core i5 machine as dom0. After some hours of syncing a raid10 array (8 sata disk) I noticed a steadily increasing loadavg. I think without reasonable i/o wait or cpu utilization the loadavg on this system should be very lower. If this loadavg is normal I would be greatful if somone could explain why. The screenshots below show that there is neither much i/o wait nor much cpu utilization. top - 09:10:25 up 9:26, 1 user, load average: 7.24, 7.63, 7.72 Tasks: 116 total, 4 running, 112 sleeping, 0 stopped, 0 zombie Cpu0 : 0.0%us, 42.5%sy, 0.0%ni, 57.5%id, 0.0%wa, 0.0%hi, 0.0%si, 0.0%st Cpu1 : 0.0%us, 1.3%sy, 0.0%ni, 97.7%id, 0.0%wa, 0.0%hi, 0.0%si, 1.0%st Cpu2 : 0.0%us, 0.0%sy, 0.0%ni,100.0%id, 0.0%wa, 0.0%hi, 0.0%si, 0.0%st Cpu3 : 0.0%us, 10.0%sy, 0.0%ni, 89.0%id, 0.0%wa, 0.0%hi, 0.0%si, 1.0%st Mem: 7805952k total, 809612k used, 6996340k free, 112092k buffers Swap: 0k total, 0k used, 0k free, 341304k cached [root at vserver ~]# iostat -d -x sda sdb sdc sdd sde sdf sg sdh Linux 2.6.18-164.6.1.el5xen (vserver.zimmermann.com) 20.11.2009 Device: rrqm/s wrqm/s r/s w/s rsec/s wsec/s avgrq-sz avgqu-sz await svctm %util sda 1364,57 0,66 1820,12 0,89 25477,44 12,37 14,00 1,11 0,61 0,41 75,10 sdb 1167,12 0,68 2017,45 0,89 25476,53 12,47 12,63 1,16 0,57 0,39 79,49 sdc 1308,06 0,66 1876,65 0,91 25477,64 12,50 13,58 1,14 0,61 0,42 78,73 sdd 1267,27 0,66 1917,28 0,92 25476,32 12,57 13,29 1,09 0,57 0,42 80,16 sde 1146,76 0,63 2037,99 0,87 25477,94 11,96 12,50 0,98 0,48 0,31 63,80 sdf 1126,88 0,64 2057,62 0,87 25475,99 12,02 12,38 1,08 0,52 0,34 69,89 sdh 472,21 0,66 2712,31 0,92 25476,13 12,43 9,39 0,66 0,24 0,15 41,03 [root at vserver ~]# cat /proc/loadavg 7.22 7.58 7.69 8/129 23348 Best regards, Günter Zimmermann