----- "Tait Clarridge" <tait at clarridge.ca> wrote: > After you have been given a trunk port with a native vlan (for eth0, > allowing you to set an IP for this connection) you can run or script > the > following: > > - Load the VLAN module [...] > If you wanted to script it to run at boot time you can create a > simple > for loop with a list of VLANs to use. The init scripts support VLANs and bridges out of the box. Adding more scripts is not necessary. I concur that separating the 4 interfaces as the original author suggested is a poor use of resources. If there are any policies in place for physical network isolation for management, it would be a better idea to get a LOM or a separate NIC for out of band management and bond the 4 primary interfaces for general traffic. -- Christopher G. Stach II