[CentOS-virt] KVM with bridge in one interface
knura9 at gmail.com
Sat Jun 26 09:54:00 EDT 2010
On Fri, Jun 25, 2010 at 3:26 AM, Armando Montiel
<armando.montiel at gmail.com> wrote:
> I have only one ethernet port in a remote server. (eth0)
> I have a public address with x.x.x.164 netmask 255.255.255.240 gw x.x.x.161
I am assuming the above is assigned to the physical device eth0, right?
>From your netmask information the following is your IP params for your subnet.
Network range - x.x.x.160 - x.x.x.175
Usable range - x.x.x.161 - x.x.x.174
> and want to use in my guest OS the next available ip address (x.x.x.165 netmask 255.255.255.240 gw x.x.x.161)
> Is this posible with brctl to achieve this?
> I did a file called ifcfg-xenbr0 with:
> then reboot, after that i use:
> # brctl addif xenbr0 eth0
> I was connected to my remote server but problems begin when I assigned the x.x.x.165 ip addres to the guest OS with
> virt-manager to begin installation. I lost the remote connection. Maybe I miss something like this? :
> iptables -I FORWARD -m physdev –physdev-is-bridged -j ACCEPT
You have not disclosed how you are connecting to the "host" OS a
priori your VM installation. Do you mean the above rule should be on
the "host" OS? I don't think so unless you have enabled firewall on
the host. I would suggest to disable the firewall until you are done
with the VM setup.
> to avoid loosing the connection ?
> i'm still receiving ping from x.x.x.165 but x.x.x.164
>From the above it appears you are doing Xen virtualization. I have
no experience with Xen but do with the Linux KVM and I do think that
the basic networking fundamentals would be uniform, irrespective of
the virt platform.
(1) With Bridge, you cannot assign an IP to the physical interface, in
your case eth0.
(2) The IP number is assigned to the bridge instead, in your case
x.x.x.164 would be assigned to the bridge.
(3) My KVM setups need "tap" (tunctl) interfaces to be bound to the
(4) The VM guest sees a regular NIC (as emulated by the host VM
environment), which is bound to the "tap" interfaces on the host OS.
The bridge being bound to the tap becomes the ethernet viaduct between
the guest VM and the rest of the world.
Therefore, I believe you need to move your host IP to the bridge,
define a tap which is bound to the bridge and then present the tap to
the VM in whichever way it is supposed to be for your virt. platform.
-- Arun Khan
More information about the CentOS-virt