> IIRC you're connected to the serial console of the guest, so if your > software isn't setup to use the serial port nothing will happen (or > output only garbage). I found instructions here http://blog.zelut.org/2010/05/05/configure-serial-console-access-on-centos-5/ and it kinda works - I can see the start of the boot process, and once finished, I can login via serial console, but do not see the boot output. Still, better than nothing. --------------------------------------------------------------- This message and any attachments may contain Cypress (or its subsidiaries) confidential information. If it has been received in error, please advise the sender and immediately delete this message. ---------------------------------------------------------------