Gene, I think you should find the answers in * http://wiki.centos.org/HowTos/Xen/Xen4QuickStart/Xen4Libvirt (bottom of page) * http://wiki.xenproject.org/wiki/Migration_Guide_To_Xen4.1%2B * http://wiki.xenproject.org/wiki/Network_Configuration_Examples_%28Xen_4.1%2B%29 * http://wiki.xenproject.org/wiki/XL_vs_Xend_Feature_Comparison may also be relevant If not, circle back to the list and I am sure someone else will be able to answer Regards Lars On 29 Jan 2015, at 08:39, Gene <gh5046 at gmail.com> wrote: > I normally use the network-script parameter in the '/etc/xen/xend-config.sxp' configuration file to configure network bridges. However, the latest release of Xen4CentOS (which comes with Xen 4.4.1) has xend disabled by default. > > Can I continue to use network-script without xend? If not what is the recommended method for automatically configuring network bridges with the latest release of Xen4CentOS? > > I know I can just enable xend to continue using this script, but since Xen 4.5 is apparently dropping xend altogether I figure I should change my standard configuration starting now. > > Thanks in advance for your time. > > -Gene > > _______________________________________________ > CentOS-virt mailing list > CentOS-virt at centos.org > http://lists.centos.org/mailman/listinfo/centos-virt -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos-virt/attachments/20150129/54d6f6b5/attachment-0006.html>