On Fri, Mar 31, 2017 at 05:06:53PM +0200, Sven Kieske wrote: > On 31/03/17 15:55, C. L. Martinez wrote: > > I need to attach two physical interfaces to a guest and these phy interfaces have IP and routes assigned and I need to get them off the main routing table. > > I do not understand this. > > You can attach a physical (or virtual, doesn't matter), interface to any > given vm, without assigning routes or IPs to these interfaces directly. No, I can't because this host doesn't support PCI passthrough. One of these interfaces is a wireless nic. > > Just do the network configuration inside the vm, and the routing, well > on your router? You will just need the route for the vm networks on your > host, but what is your attack scenario to keep this separated from other > routes on this host? you need at least CAP_NET_ADMIN to fiddle with those. How? If the same host routes Internet traffic in the main routing table I expose host's services to Internet. > > -- > Mit freundlichen Grüßen / Regards > > Sven Kieske > > Systemadministrator > Mittwald CM Service GmbH & Co. KG > Königsberger Straße 6 > 32339 Espelkamp > T: +495772 293100 > F: +495772 293333 > https://www.mittwald.de > Geschäftsführer: Robert Meyer > St.Nr.: 331/5721/1033, USt-IdNr.: DE814773217, HRA 6640, AG Bad Oeynhausen > Komplementärin: Robert Meyer Verwaltungs GmbH, HRB 13260, AG Bad Oeynhausen > > _______________________________________________ > CentOS-virt mailing list > CentOS-virt at centos.org > https://lists.centos.org/mailman/listinfo/centos-virt -- Greetings, C. L. Martinez