On Wed, May 17, 2017 at 8:54 AM, Jerry <jerryubi at gmail.com> wrote: > > > On Wed, May 17, 2017 at 8:44 AM, George Dunlap <dunlapg at umich.edu> wrote: > >> On Wed, May 17, 2017 at 4:20 PM, Jerry <jerryubi at gmail.com> wrote: >> > This is what's defined in /etc/default/grub following the install of the >> > Xen: >> > >> > GRUB_CMDLINE_XEN_DEFAULT="dom0_mem=1024M,max:1024M cpuinfo >> com1=115200,8n1 >> > console=com1,tty loglvl=all guest_loglvl=all" >> > GRUB_CMDLINE_LINUX_XEN_REPLACE_DEFAULT="console=hvc0 earlyprintk=xen >> > nomodeset" >> > >> > I didn't set these myself, this is what the xen package (or one of its >> > dependencies) is doing. >> >> It's the CentOS Xen package setting this. But the Xen option >> "console=com1,tty" should make it such that Xen sends its output >> *both* to the serial line, *and* the monitor. >> >> I take it you're not seeing any Xen output at all on your IPMI console? >> >> -George >> > > The boot messages are suppressed, but if it boots successfully the login > prompt shows up. If I remove console=hvc0 both the boot messages and login > prompt show up. > > Note: the IPMI console I'm looking at is just the local monitor being > redirected. It isn't a special device/driver. > > I'll try what Konrad is suggesting, setting this: > > console=hvc0 console=tty > > And will see what happens. It'll be a few hours until I can try it out. > > Thank you to every one that has responded, I appreciate the help. > > Jerry. > > Setting both hvc0 and tty is working as desired. Thanks again to everyone that replied. I'm updating my kickstart script to include adding console=tty in addition to the other. Jerry -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos-virt/attachments/20170517/b6ca97c6/attachment-0005.html>