[Centos] 3Ware Escalade 9500S controller question
Shawn M. Jones
smj at littleprojects.orgThu Sep 9 03:49:12 UTC 2004
- Previous message: [Centos] migrating RH9 to CentOS-3
- Next message: [Centos] 3Ware Escalade 9500S controller question
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Greetings folks, I'm currently redoing my home server as one of the hard drives in my RAID-1 array went down and I'm going to replace the lot of it with a 3Ware Escalade 9500S RAID capable card and four Seagate 200GB SATA drives. These drives are supposedly the coolest and quietest SATA drives available (better than the Maxtors I had anyway) and the capacity upgrade on the server is worth the $$$ at this point. I'm planning on running them in RAID-5 for maximum disk space and performance. Are there any 3Ware Escalade/SATA issues I should be aware of when building this new server utilizing CentOS-3? The card was supposedly supported under RH9, so I figured RHEL3 (or clones) would be fine. Thanks in advance for the feedback, - --Shawn - -- - -- Shawn M. Jones <smj at littleprojects.org> http://www.littleprojects.org -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.4 (GNU/Linux) iD8DBQFBP9K3gaOAAb5cjIkRArVLAJ90/xrq4j8qsu8oAj6vaJlBS5pUAQCggH3a fUKM52EQlz/BzR9q5dLKrvQ= =RfLF -----END PGP SIGNATURE-----
- Previous message: [Centos] migrating RH9 to CentOS-3
- Next message: [Centos] 3Ware Escalade 9500S controller question
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the CentOS mailing list