ryanag at zoominternet.net wrote: > I want to add two IP ranges on one NIC card (eth0 and eth0:1). Has > anyone done this before? > > The CentOS 4 gui keeps locking up when I try it there and the command > line ifconfig seems to work, but ifup always returns the error that is > never heard (no such device) of eth0:1 If you do ifconfig, then you don't need to do ifup afterwards. It comes up as part of the command. ifup is if you have the device or alias defined and it's not up and running. For CentOS/RHEL, you define the IP aliases in: /etc/sysconfig/network-scripts In fact, assuming you want the ranges to come up after reboot, it's best to put them there. Note that Linux (as opposed to Solaris, I think?) uses eth0:0 as the first IP alias of eth0 (eth0 itself being the primary/non-alias IP address), not eth0:1. eth0:1 would be for the 2nd IP alias of eth0. But if you're doing a range, then instead of /etc/sysconfig/network-scripts/ifcfg-eth0:0, you'd want /etc/sysconfig/network-scripts/ifcfg-eth0-range0 and then instead of IPADDR=, use IPADDR_START=starting.ip.address.here and IPADDR_END=ending.ip.address.here johnn