[Bulk] [CentOS] hda dma seek errors

Wed Aug 3 12:57:34 UTC 2005
Manuel BERTRAND <manuel.bertrand at lif.univ-mrs.fr>

Change your IDE cable, be happy.
(old IDE have fewer wire)
M

BRUCE STANLEY wrote:

>
>--- Rohan Walsh <rohan_walsh at yahoo.com.au> wrote:
>
>  
>
>>On Tue, 2005-08-02 at 23:58 -0400, Kanwar Ranbir Sandhu wrote:
>>    
>>
>>>On Tue, 2005-02-08 at 19:57 -0700, BRUCE STANLEY wrote:
>>>      
>>>
>>>>I am getting occasional seek error on my boot drive.
>>>>The messages are as follows:
>>>>
>>>>pshda: dma_intr: status = 0x51 { Drive ReadySeekComplete Error }
>>>>  hda: dma_intr: error= 0x84 { DriveStatusError BadCRC }
>>>>  ide: failed opcode was: unknown
>>>>        
>>>>
>>>I've recently seen similar errors on an old server here, and all my
>>>Googling seems to indicate an early sign of imminent drive failure.
>>>
>>>Some people reported resolving the issue by making changes to DMA
>>>settings with hdparm, or changing something in the BIOS.  However, in
>>>most cases, the recommendations were:
>>>
>>>1. Backup data, ASAP, and wait for failure before moving to new disk
>>>2. Use fdisk to map out the bad sectors.
>>>3. Get a new HD, ASAP.
>>>      
>>>
>>I used these errors as a good reason to buy a bigger drive and the new
>>drive had the same error messages. After testing with seagates tool, I
>>can find no problem with either drive. I disable dma as a temporary
>>solution, but I think it is not a drive fault in my case. Do back up :)
>>
>>    
>>
>
>
>How did you go about disabling dma?
>
> 
>
>_______________________________________________
>CentOS mailing list
>CentOS at centos.org
>http://lists.centos.org/mailman/listinfo/centos
>  
>

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++