adrian kok <adriankok2000 at yahoo.com.hk> wrote: > Hi all > I change the monitor to LG LCD > but x window couldn't start because of the "out of > range" signal in the monitor > How can I fix this problem If there arescan ranges (Horiz/Vert) defined in the monitor section of /etc/X11/xorg.conf, remove them. The video card should detect and pass along the correct scan ranges. If they are explicitly defined, X will assume you know what you are doing. It's very likely your old monitor supports higher scan ranges than the new LCD. Otherwise, pull out your manual for your LG monitor and put in the correct scan ranges in the Monitor section. -- Bryan J. Smith Professional, Technical Annoyance b.j.smith at ieee.org http://thebs413.blogspot.com ---------------------------------------------------- *** Speed doesn't kill, difference in speed does ***