So you've used the 2120s? -- <<JAV>> ---------- Original Message ----------- From: Jacob Robert Wilkins <jrw at nplus1.net> To: CentOS discussion and information list <centos at caosity.org> Sent: Fri, 7 Jan 2005 13:56:12 -0500 Subject: Re: [Centos] SuperServer 6024H-82R and Centos 3.3 > I run a lot of SuperMicro boxes. Most of mine are 6013P variants, > with the same Adaptec chipset. I haven't had any problems with > CentOS supporting these controlers. > > jrw > > On Fri, Jan 07, 2005 at 01:50:57PM -0500, Ryan Lane wrote: > > On Fri, 7 Jan 2005 14:08:53 -0400, Joe Polk <listuser at javelinux.com> wrote: > > > > I've had some very odd Adaptec SCSI problems in the past (that sound > > very similar to what you are describing). Not sure if this is related > > or not, because it's a different card. The solution to my problem was > > to run an SMP kernel, even though I didn't have any SMP machine. > > Something with the uniprocessor kernel caused problems very similar to > > what you are describing. > > > > And my problem was not just with CentOS or RedHat....it was the same > > with all linux distros (kernels 2.4 and 2.6). > > > > This problem sucks because almost all installers that I know of use a > > uniprocesser kernel. Depending on how bad you want it, you could > > create a custom installer that uses an SMP kernel. That's what I had > > to do. > > > > -Ryan > > _______________________________________________ > > CentOS mailing list > > CentOS at caosity.org > > http://lists.caosity.org/mailman/listinfo/centos > _______________________________________________ > CentOS mailing list > CentOS at caosity.org > http://lists.caosity.org/mailman/listinfo/centos ------- End of Original Message -------