[CentOS] CentOS and Red Hat SATA drivers

[Kaplan, Andrew H.]

Hi there -- The version number associated with the driver is 0. There is no
further information available other than it was listed within the driver disk
creation utility as a Red Hat Enterprise 3 driver. Versions 3.3 and 3.4 are the
only two of the 3.x line that support the x86_64 architecture. Which version of
the two would you recommend as a starting off point?

-----Original Message-----
From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On Behalf Of
Johnny Hughes
Sent: Wednesday, July 27, 2005 12:57 PM
To: CentOS mailing list
Subject: Re: [CentOS] CentOS and Red Hat SATA drivers


On Wed, July 27, 2005 11:51 am, Kaplan, Andrew H. said:
> Hi there --
>
> I was going to experiment with a CentOS x86_64 install in the following
> manner:
> One of our new dual-xeon servers is using an Adaptec SATA controller card
> that
> has drivers available for Red Hat Advanced Server 2.1 and Enterprise Linux
> 3.0.
> I was going to create the drivers for one or the other and then attempt an
> install via the linux dd command. My question is, would either of these
> drivers
> work with a version of CentOS, and if so what version could I use? Thanks.

Maybe ... Usually, the kernel version for the driver needs to match the
kernel it is built for.  So, you would use CentOS-3 or CentOS-2.1 and get
the ISO that you need, based on the driver.

We did not release a CentOS-3.0 ... so there is not a CD for that.

What update # is the RHEL driver for (ie, RHEL-4 Update 2, etc.)

You can find old CDs and trees here:

http://vault.centos.org/

-- 
Johnny Hughes
<http://www.HughesJR.com/>

_______________________________________________
CentOS mailing list
CentOS at centos.org
http://lists.centos.org/mailman/listinfo/centos