>You might also try running the dmesg command after plugging an SD card in to >see if it is recognized by the system at all. > This is the result of dmesg: Initializing USB Mass Storage driver... usbcore: registered new driver usb-storage USB Mass Storage support registered. usb 1-1.1: new full speed USB device using address 7 scsi0 : SCSI emulation for USB Mass Storage devices Vendor: BUFFALO Model: CF CARD Reader Rev: 3.06 Type: Direct-Access ANSI SCSI revision: 02 USB Mass Storage device found at 7 Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0 Device not ready. Make sure there is a disc in the drive. Dave