[CentOS] Installing CentOS on RAID PATA not SATA - A8V
Chris Mauritz
chrism at imntv.comWed May 18 22:37:51 UTC 2005
- Previous message: [CentOS] Installing CentOS on RAID PATA not SATA - A8V
- Next message: [CentOS] Installing CentOS on RAID PATA not SATA - A8V
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Bryan J. Smith <b.j.smith at ieee.org> wrote: >If you want just ATA/SATA support of single drives, that will work. >The RAID functionality will never work, because it is 100% software-based >(the 16-bit BIOS setup is just for boot-time). > >I call this "FRAID" and it is not hardware RAID (it adds *0* hardware). >Any drivers will be proprietary and not open source, because they >contain RAID code licensed from a 3rd party that is not GPL (and >never will be, because it is the core IP of that 3rd party and the >lifeblood of their business). > > > Be very 'FRAID. 8-) If it was me, I'd figure out how to get the drives recognized as plain old ATA drives and then use the software RAID striping native to Linux rather than depend on the promise card to do anything other than act as an ATA controller. I think the likelihood of roaching the volume while depending on the promise software RAID bandaid is probably rather high for no performance payoff whatsoever. Cheers, C
- Previous message: [CentOS] Installing CentOS on RAID PATA not SATA - A8V
- Next message: [CentOS] Installing CentOS on RAID PATA not SATA - A8V
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the CentOS mailing list