[CentOS] PE-2850 to AX100 via Qlogic Card (QLA200 HBA) on CentOS 4.1

I found drivers who seems to be arch independent at 
http://qlogic.com/support/oem_product_detail.asp?p_id=680&oemid=284&oemname=QLA200

but, I've got the same error:
---
# ./qlinstall

#*********************************************************#
#            QLogic HBA Linux Driver Installation         #
#                  Version:  1.00.00b2pre16               #
#*********************************************************#

Kernel version: 2.6.9-11.ELsmp
Distribution: CentOS release 4.1 (Final)

Found QLogic Fibre Channel Adapter in the system
    1: QLA6312
Installation will begin for following driver(s)
    1: qla2xxx version: v8.00.03b

Preparing...                
##################################################
error: %pre(qla2xxx-v8.00.03b-1.noarch) scriptlet failed, exit status 255
error:   install: %pre scriptlet failed (2), skipping qla2xxx-v8.00.03b-1
---
Do you know what is this "scriptlet" error?
thanks

> Johnny Hughes wrote:
>
>> If you installed the x86_64 arch ... Yes, it looks like that RPM was
>> written for an i686 kernel.
>>
>> Where did you get the RPM?  Do that have a SRPM?  Do they have an RPM
>> for x86_64.
>>  
>>
> From the CD shipped with the card (by Dell, it was an all in one: 
> PE-2850 & QLA-200HBA & EMC AX-100). There is no source on the CD nor 
> X86-64 version. I can't find any driver for the QLA-200 on 
> support.qlogic.com, except the windows one... I keep searching.
>
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>> CentOS mailing list
>> CentOS at centos.org
>> http://lists.centos.org/mailman/listinfo/centos
>>  
>>
>
> _______________________________________________
> CentOS mailing list
> CentOS at centos.org
> http://lists.centos.org/mailman/listinfo/centos
>