I found drivers who seems to be arch independent at http://qlogic.com/support/oem_product_detail.asp?p_id=680&oemid=284&oemname=QLA200 but, I've got the same error: --- # ./qlinstall #*********************************************************# # QLogic HBA Linux Driver Installation # # Version: 1.00.00b2pre16 # #*********************************************************# Kernel version: 2.6.9-11.ELsmp Distribution: CentOS release 4.1 (Final) Found QLogic Fibre Channel Adapter in the system 1: QLA6312 Installation will begin for following driver(s) 1: qla2xxx version: v8.00.03b Preparing... ################################################## error: %pre(qla2xxx-v8.00.03b-1.noarch) scriptlet failed, exit status 255 error: install: %pre scriptlet failed (2), skipping qla2xxx-v8.00.03b-1 --- Do you know what is this "scriptlet" error? thanks > Johnny Hughes wrote: > >> If you installed the x86_64 arch ... Yes, it looks like that RPM was >> written for an i686 kernel. >> >> Where did you get the RPM? Do that have a SRPM? Do they have an RPM >> for x86_64. >> >> > From the CD shipped with the card (by Dell, it was an all in one: > PE-2850 & QLA-200HBA & EMC AX-100). There is no source on the CD nor > X86-64 version. I can't find any driver for the QLA-200 on > support.qlogic.com, except the windows one... I keep searching. > >> ------------------------------------------------------------------------ >> >> _______________________________________________ >> CentOS mailing list >> CentOS at centos.org >> http://lists.centos.org/mailman/listinfo/centos >> >> > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos >