Quoting Craig White <craigwhite at azapple.com>: > OK - I only have one tape drive but a real problem these days backing > up. I ***may*** have connected the SCSI connector to the 'other' > external connector when shifting stuff around in the rack. > > # cat /proc/scsi/scsi > Attached devices: > Host: scsi0 Channel: 05 Id: 06 Lun: 00 > Vendor: SEAGATE Model: ULTRIUM06242-XXX Rev: 1514 > Type: Sequential-Access ANSI SCSI revision: 03 > Host: scsi0 Channel: 05 Id: 06 Lun: 01 > Vendor: SEAGATE Model: ULTRIUM06242-XXX Rev: 1514 > Type: Sequential-Access ANSI SCSI revision: 03 > > How do I get it 're-parse' the scsi system so it only indicates one > ULTRIUM tape drive? Me suspects this is why I am having backup issues. Hm, reboot? ;-) However, it might not help. Some hardware likes to be seen on more than one LUN. I used to have one ancient 8mm Exabyte tape drive that would report it has about 8 LUNs. Go figure. ---------------------------------------------------------------- This message was sent using IMP, the Internet Messaging Program.