On 4/28/06, Karanbir Singh <mail-lists at karan.org> wrote: > > ankush grover wrote: > > > > What is the reason that FC4 and Centos4.0 are failing with the > > > installation? What should I do to get rid of the problem ? > > > > you need to provide more info, like what sort of h/w is installed in > > that machine ? > > > Combo SOLTC-4836k ATAPI CD/DVD-ROM > > ATI Radeon Xpress 200 Graphics Card > > ATI Chipset RC410 > > Intel Pentium IV 2.93 Processor > > 512 RAM DDR2 Kingston > > Agere Modem (Internal) > > Realtek High Definition Audio > > Bluetooth and S-Video Enabled > > Compaq 7540 17" Monitor > > > > what is the actual problem ? at what stage and how does the install fail ? > > w.r.t the display, once installed run : system-config-display --reconfig > --noui > > that should give you a usable setup, that you can then install the ati > drivers onto ( get them from the ati website ) > > hey, When the Centos 4.0 starts it installing after few minutes errors will start coming up hdc: IRQ Probe failed (Oxfcfa) hdd: IRQ Probe failed (Oxfcfa) hdc: lost interrupt. There is no problem with the cds as on the other machines I am able to install those cds but on this particular machine things are failing. I am reconfigure or system-config-display but I am should be able to reach that stage where I can issue this command If I am not able to install the OS how can I issue this command. I tried Suse 10.0 it got installed but when the KDE comes it shows an error "Frequency out of range". Suse 10.0 works fine If I boot into the init level 3 but not in init level 5. But Centos and FC4 are not reaching that stage that I can boot to init level 3 they are failing within few minutes of installation process. Thanks & Regards Ankush Grover -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos/attachments/20060428/6ad3f610/attachment-0005.html>