[CentOS] Scripting port scans

mike.redan at bell.ca mike.redan at bell.ca
Thu Dec 7 19:21:25 UTC 2006


It kinda looks like he is looking to use return values to do his
scripting....

If so, try netcat.

nc -z -w3 192.168.1.1 80

That will return 0 on open port. 1 on close port. 1 on filtered port.
Waits 3 seconds for a response.
Wrap in a loop as needed...


Mike

-----Original Message-----
From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On
Behalf Of Matt Shields
Sent: December 7, 2006 1:55 PM
To: CentOS mailing list
Subject: Re: [CentOS] Scripting port scans


Use nmap.  Here I'm scanning my home network for any port 80 that's open

nmap -p 80 192.168.1.0/24

Matt Shields
Cyberbite Network - www.cyberbite.com

On 12/7/06, Ugo Bellavance <ugob at camo-route.com> wrote:
> Hi,
>
> I need to test one specific port on a serie of Ip addresses that I 
> own, I thought about using nmap or telnet, but both return the same 
> value, no matter if the port is open or filtered.
>
> Anyone has an idea, before I start scripting to analyse the output of 
> the command?
>
> Regards,
>
> Ugo
>
> _______________________________________________
> CentOS mailing list
> CentOS at centos.org http://lists.centos.org/mailman/listinfo/centos
>
_______________________________________________
CentOS mailing list
CentOS at centos.org http://lists.centos.org/mailman/listinfo/centos



More information about the CentOS mailing list