[CentOS] HP NetServer LC2000r and LH6000r install woes

Steve Huff

shuff at vecna.org
Fri Jan 20 16:02:12 UTC 2006


hello folks!

i've got four HP NetServers, two LC2000r and two LH6000r.  the CentOS  
4.2 ServerCD can't see hard drives on any of them.

each machine has a HP NetRAID controller; the LC2000rs have a  
NetRAID-1Si and the LH6000rs have an Integrated NetRAID.  each  
controller has three 9GB drives, two mirrored and one hotspare.

each machine boots ok (the LC2000rs need "linux noacpi" or they  
complain about being in a weird power management state and panic),  
each loads the megaraid driver, but none of them can see any volumes.

fixes i have already tried:

1) on the LH6000rs i have disabled "Smart IRQ" reallocation; on the  
LC2000rs i have disabled "Reserve PCI Bus Numbers" as described in  
this document:

http://tldp.org/HOWTO/HP-HOWTO/hp-hardware.html#AEN792

these fixes have made the megaraid driver stop complaining about IRQ  
conflicts or routing errors.

2) i have tried switching each NetRAID controller from I20 to "Mass  
Storage" mode; no change.

3) i have tried manually adding the i2o_block driver; no change.

has anyone encountered similar problems with this hardware?  better  
yet, has anyone resolved them?  any other ideas?

do i need to do anything to the logical volumes on the NetRAIDs other  
than create and initialize them?

i'm currently downloading the full CentOS install media, in case this  
is some sort of deficiency in the ServerCD.

thanks,
steve

---
If this were played upon a stage now, I could condemn it as an  
improbable fiction. - Fabian, Twelfth Night, III,v




More information about the CentOS mailing list