[CentOS] RE: Broadcom NIC Binding under Centos 4.2

[ABOKHALAF, Nassri Abdellatif]

Ethernet Channel Bonding Driver: v2.6.1 (October 29, 2004)

Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: eth0
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0

Slave Interface: eth0
MII Status: up
Link Failure Count: 0
Permanent HW addr: 00:15:60:ad:a0:8a

Slave Interface: eth1
MII Status: up
Link Failure Count: 0
Permanent HW addr: 00:15:60:ad:a0:89

> show me your modprobe.conf


/etc/modprobe.conf

alias vlan 8021q
alias bond0 bonding
options bonding miimon=100 mode=1
alias eth0 tg3
alias eth1 tg3
alias scsi_hostadapter cciss
alias usb-controller ehci-hcd
alias usb-controller1 uhci-hcd
alias net-pf-10 off

/etc/sysconfig/network
NETWORKING=yes
HOSTNAME=dns.refertelecom.pt
GATEWAY=10.192.32.254
GATEWAYDEV=bond0.201

eth0
DEVICE=eth0
BOOTPROTO=static
TYPE=Ethernet
ONBOOT=yes
SLAVE=yes
MASTER=bond0

eth1
DEVICE=eth1
BOOTPROTO=static
TYPE=Ethernet
ONBOOT=yes
SLAVE=yes
MASTER=bond0

bond0.201
DEVICE=bond0.201
ONBOOT=yes
IPADDR=10.192.32.37
NETMASK=255.255.255.0

bond0
DEVICE=bond0
ONBOOT=yes


Regards,
Nassri