[CentOS] Two ethernet adapters and more
Craig White
craigwhite at azapple.com
Mon Jan 23 22:36:23 UTC 2006
On Mon, 2006-01-23 at 17:29 -0500, Robert Moskowitz wrote:
> Craig, you are always such a wonderful source of help.
>
> At 05:14 PM 1/23/2006, Craig White wrote:
> >On Mon, 2006-01-23 at 16:57 -0500, Robert Moskowitz wrote:
> > >
> > > So question #1 is how to use netconfig to setup eth1 without
> > messing with eth0.
> >----
> >don't know - never used it.
> >
> >try...
> >
> >cd /etc/sysconfig/network-scripts
> >cp ifcfg-eth0 ifcfg-eth1
> >
> >and then edit ifcfg-eth1 to your liking
>
> VI here I come! At least now I know which files to work with.
>
> >----
> > >
> > > #2) NETCONFIG did not setup my hostname and domain. I had to go
> > > in with VI to resolv.conf and sysconfig/network. Is there a tool for this?
> >----
> >simply edit /etc/sysconfig/network
> >
> >change the hostname to anything you want it to be - suggest that you
> >make sure this entry also exists in /etc/hosts
> >
> >Also when using 2 eth devices per above, set the gateway address here...
> >
> >GATEWAYDEV=eth0 # fix for your situation
> >GATEWAY=ip_addr_of_gateway
>
> Do these go in sysconfig/network ?
----
YES
---
>
> > >
> > > #3) How do I figure out which board is which. Other than looking
> > > at the MAC address and using PCISNIFFER to then relate that to one of
> > > the boards (well, one 'builtin'). Also how do I determine which
> > > board is using which IRQ.
> >----
> >dmesg|less
> >
> >or
> >
> >lspci -vv
>
> The later has given me somethings to work with. Plus also some help
> on moding the zaptel config files from some wiki stuff I have seen on
> zaptel clones.
----
good
Craig
More information about the CentOS
mailing list