I really hope someone has a clue on this one.... :) I've got a 2.2TB array mounted on a 3ware 9500 controller. I installed it last week ensuring that LBA was enabled and using gpt with parted to get the full size available on one array. I also think I chose reiserfs for the array. We then moved ALOT of data to the array. Problem now is that after a reboot LBA doesn't seem to be in effect. From dmesg: sdc : very big device. try to use READ CAPACITY(16). SCSI device sdc: 4374845440 512-byte hdwr sectors (2239921 MB) SCSI device sdc: drive cache: none sdc : very big device. try to use READ CAPACITY(16). SCSI device sdc: 4374845440 512-byte hdwr sectors (2239921 MB) SCSI device sdc: drive cache: none sdc: sdc1 Attached scsi disk sdc at scsi1, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0 Attached scsi generic sg1 at scsi0, channel 0, id 7, lun 0, type 0 Attached scsi generic sg2 at scsi1, channel 0, id 0, lun 0, type 0 I can no longer mount sdc1; the error is the usual invalid superblock. parted does however list the correct size and filesystem. Any tips on how I can get the array mounted again? And what might have changed since last boot? :) I've rolled my own kernel to get reiser support, but I haven't recompiled or done any changes... Regards, Harald -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos/attachments/20060103/056f1b37/attachment-0004.html>