On Mon, 2006-01-23 at 17:29 -0500, Robert Moskowitz wrote: > Craig, you are always such a wonderful source of help. > > At 05:14 PM 1/23/2006, Craig White wrote: > >On Mon, 2006-01-23 at 16:57 -0500, Robert Moskowitz wrote: > > > > > > So question #1 is how to use netconfig to setup eth1 without > > messing with eth0. > >---- > >don't know - never used it. > > > >try... > > > >cd /etc/sysconfig/network-scripts > >cp ifcfg-eth0 ifcfg-eth1 > > > >and then edit ifcfg-eth1 to your liking > > VI here I come! At least now I know which files to work with. > > >---- > > > > > > #2) NETCONFIG did not setup my hostname and domain. I had to go > > > in with VI to resolv.conf and sysconfig/network. Is there a tool for this? > >---- > >simply edit /etc/sysconfig/network > > > >change the hostname to anything you want it to be - suggest that you > >make sure this entry also exists in /etc/hosts > > > >Also when using 2 eth devices per above, set the gateway address here... > > > >GATEWAYDEV=eth0 # fix for your situation > >GATEWAY=ip_addr_of_gateway > > Do these go in sysconfig/network ? ---- YES --- > > > > > > > #3) How do I figure out which board is which. Other than looking > > > at the MAC address and using PCISNIFFER to then relate that to one of > > > the boards (well, one 'builtin'). Also how do I determine which > > > board is using which IRQ. > >---- > >dmesg|less > > > >or > > > >lspci -vv > > The later has given me somethings to work with. Plus also some help > on moding the zaptel config files from some wiki stuff I have seen on > zaptel clones. ---- good Craig