Signal 11 is a bus error. I would try turning down the clock on your CPU. If this doesn't fix the problem and the memory isn't bad and the CPU isn't bad then I would go with the MotherBoard. On 6/1/06, Alfred von Campe <alfred at 110.net> wrote: > > On May 31, 2006, at 17:36, Rodrigo Barbosa wrote: > > > > On Wed, May 31, 2006 at 05:22:29PM -0400, Alfred von Campe wrote: > >> kickstart file via http, but then dies with a "installation exited > >> abnormally -- received signal 11" message. I've done this > >> successfully in the past. Can a misconfigured kickstart file cause > >> this problem? How can I debug this? > > > > In 90% of the cases, a signal 11 means faulty memory. > > In 9% of the cases, something wrong with the processor (usually > > overheating) > > > > 1%: Others reasons > > > > Suggestion: Running memtest86 > > I must be in the other 1% of reasons. I ran memtest86 and I also > tried it on other systems. These are brand new IBM (Lenovo) > ThinkCentre M52 systems with 4GB of RAM. On all systems it fails > with the same error. So I ask again, can a misconfigured kickstart > configuration file cause this problem? If not, how can I debug > this? How can I capture any logs from the kickstart session? None > of the virtual consoles appear to have a running shell where I can > access the system. > > On a related note, what's the consensus on enabling hyperthreading on > a CentOS system? Good, bad, indifferent? The systems will be used > as developer workstations. > > Thanks, > Alfred > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > -- Thx Joshua Gimer -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos/attachments/20060601/1ca05dcc/attachment-0005.html>