On Sun, 18 Jun 2006 19:04:58 -0600 "Joshua Gimer" <jgimer at gmail.com> wrote: > IP routing should be turned off by default. You will also need to edit your > /etc/sysctl.conf file so that the line that reads: > > net.ipv4.ip_forward=0 reads net.ipv4.ip_forward=1 > > This will enable IP forwarding on all interfaces; if you want to enable it > on just one interface then you will need to remove the previously stated > line and add a line in /etc/sysctl.conf that reads: > > net.ipv4.conf.<interface>.forwarding=1 ## Replacing interface with the > appropriate interface (ex. eth0). I bet that's it. I don't recall ever doing this before but then again the previous installation was pretty old (RH 7.2). Unfortunately I won't know for sure until I rebuild the machine because the disk just died! Note to self: Don't use an IBM Deskstar from a machine that's been sitting in the attic without air conditioning or heat for 6 years. :-/ Mike -- Michael B Allen PHP Extension for SSO w/ Windows Group Authorization http://www.ioplex.com/