[CentOS] Re: CentOS 4 and laptop and wifi works
Tom Diehl
tdiehl at rogueind.com
Sat May 27 13:39:42 UTC 2006
On Thu, 25 May 2006, Max H. wrote:
> Tom Diehl wrote:
> >
> > Have you succeeded in getting wpa encryption working with the Atheros/madwifi
> > drivers??
> >
> > My madwifi card works just fine with no encryption but I cannot get it to
> > work with the wpa encryption turned on.
>
> That I have not yet tried. I use just normal WEP encryption and it's
> always worked fine. I know WEP isn't super secure, but if I have
> anything I don't want broadcasting I simply use a wire. There aren't any
> other wireless networks in my neighborhood, so I haven't really care to
> try it.
>
> ATrpms has two different wpa_supplicant RPMs, but I don't know enough
> about WPA to say whether or not I'm on target with pointing you to this.
> From the small changelog at the bottom of these links say "added
> madwifi support," so I'm assuming it's supposed to work.
>
> <http://atrpms.net/dist/el4/wpa_supplicant/>
> <http://atrpms.net/dist/el4/wpa_supplicant-eap-fast/>
As a followup to this I got madwifi and wpa_supplicant working last night.
Whoooooooo!!
I used 0.9.0 driver from the madwifi site. I could not even get the drivers
from atrpms to bring the interface up. I must have missed something. Anyway,
I figured since the drivers on the madwifi site were newer I would go that way.
I used a specfile that I got off of the old madwifi site to build a set of rpms.
It is not real pretty but it worked.
The box has been up for pver 8 hours with no disconnects from the network. In
fact I am writing this message over the wireless network. :-)
For those interested here is the output of lspci -vv:
03:00.0 Ethernet controller: Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01)
Subsystem: PROXIM Inc Unknown device 0a40
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 168 (2500ns min, 7000ns max), Cache Line Size 20
Interrupt: pin A routed to IRQ 10
Region 0: Memory at 34000000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [44] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
lspci -n: 03:00.0 0200: 168c:0013 (rev 01)
Now I just need to find a way to manage multiple wpa encrypted connections easially.
Regards,
Tom Diehl tdiehl at rogueind.com Spamtrap address mtd123 at rogueind.com
More information about the CentOS
mailing list