On Wed, 2006-05-03 at 02:41 -0500, Johnny Hughes wrote: > On Tue, 2006-05-02 at 20:05 -0700, Craig White wrote: > > On Tue, 2006-05-02 at 20:39 -0500, Barry Brimer wrote: > > > > I have an issue with cdrecord though and I can't figure it out. I use > > > > Webmin, which basically just creates an iso and then uses cdrecord to > > > > burn it and it worked fine with previously installed CentOS 4 (I wiped > > > > and reinstalled about 8 months ago). > > > > > > > > This is the command that Webmin tries to execute... > > > > > > > > cdrecord -v dev=0,0,0 speed=4 -isosize \ > > > > '/home/Linux/CentOS-4/CentOS-4.2-i386-bin4of4.iso' > > > > > > I am certainly no expert at cdrecord .. but I would drop the "-isosize". > > > Also, you may be able to use dev=</dev/devicename> as well. > > ---- > > # cdrecord -v dev=/dev/hdc speed=4 \ > > '/home/Linux/CentOS-4/CentOS-4.2-i386-bin4of4.iso' > > cdrecord: No write mode specified. > > cdrecord: Asuming -tao mode. > > cdrecord: Future versions of cdrecord may have different drive dependent > > defaults. > > cdrecord: Continuing in 5 seconds... > > Cdrecord-Clone 2.01-dvd (i686-pc-linux-gnu) Copyright (C) 1995-2004 Jörg > > Schilling > > Note: This version is an unofficial (modified) version with DVD support > > Note: and therefore may have bugs that are not present in the original. > > Note: Please send bug reports or support requests to > > http://bugzilla.redhat.com/bugzilla > > Note: The author of cdrecord should not be bothered with problems in > > this version. > > TOC Type: 1 = CD-ROM > > scsidev: '/dev/hdc' > > devname: '/dev/hdc' > > scsibus: -2 target: -2 lun: -2 > > cdrecord: No such file or directory. Cannot open '/dev/hdc'. Cannot open > > SCSI driver. > > cdrecord: For possible targets try 'cdrecord -scanbus'. > > cdrecord: For possible transport specifiers try 'cdrecord dev=help'. > > > > I am sure that I didn't have this problem before (perhaps something > > CentOS 4.1 but I have upgraded a number of times). > > > > I just use K3B to do all my recording now with CentOS-4 ... GUI will be > the death of us all ... :) > > But I remember something about the 2.6 kernel and use of the ATAPI > target being required instead of the old IDE-SCSI method when using > cdrecord. > > I don't remember the particulars, but google might. ---- I started with google and knew that I didn't want to try passing kernel parameters like hdc=ide-scsi and couldn't find it but wasn't sure where to go with it. Turns out... dev=ATAPI:0,0,0 was the answer. Added it to both /etc/webmin/burner/config and to /etc/cdrecord.conf to be safe but from cli, I only needed to pass the dev as above, once addded to /etc/cdrecord.conf, I didn't need to bother and in webmin's config, it works fine. Thanks all Craig