[CentOS] Problems with LTO-3 and U320 on Centos 4.4

Mon Nov 13 13:55:28 UTC 2006
Joshua Baker-LePain <jlb17 at duke.edu>

On Mon, 13 Nov 2006 at 1:00pm, Plant, Dean wrote

> I thought I would give your suggestion a go and bought in a LSI 21320R
> scsi card and installed a fresh copy of CentOS 4.4. Now on boot I get
> the following error and the Overland Library is not detected. Did you
> change any options in the LSI scsi bios?

No I didn't -- it all Just Worked(TM).

> SCSI subsystem initialized
> Fusion MPT base driver 3.02.62.01rh
> Copyright (c) 1999-2005 LSI Logic Corporation
> Fusion MPT FC Host driver 3.02.62.01rh
> Fusion MPT SPI Host driver 3.02.62.01rh
> mptbase: Initiating ioc0 bringup
> ioc0: 53C1030: Capabilities={Initiator}
> scsi0 : ioc0: LSI53C1030, FwRev=01033010h, Ports=1, MaxQ=222, IRQ=169
>  Vendor: HP        Model: Ultrium 3-SCSI    Rev: G33H
>  Type:   Sequential-Access                  ANSI SCSI revision: 03
> mptbase: ioc0: IOCStatus(0x0002): Busy
> mptscsi: ioc0: attempting task abort! (sc=f7d01c80)
> scsi0 : destination target 1, lun 1
>        command = Inquiry 00 00 00 3a 00

Your changer is on a different SCSI ID from the tape drive, right (rather 
than on the same ID and a different LUN)?  It's odd that it's hanging on 
that inquiry.

Despite what you said about other OSs working with this setup, I'd check 
your cables and termination real well.  Have you done any fiddling with 
the SCSI options on the library?

-- 
Joshua Baker-LePain
Department of Biomedical Engineering
Duke University