Matthew Martz wrote: > On Wed, November 22, 2006 1:42 pm, Matthew Martz wrote: >> I'm in need of installing two NICs in a machine that are connected >> to 2 different public networks and I need both IP addresses >> accessible from the outside. The IPs are part of two completely >> different subnets. >> >> For example: >> eth0 >> IP - 10.10.10.2/30 >> GW - 10.10.10.1 >> >> eth1 >> IP - 20.20.20.6/30 >> GW - 20.20.20.5 >> >> How can I configure 2 gateways on this server? > > I should probably also mention that I want traffic that comes in over > eth0 to go out over eth0 and traffic that comes in on eth1 to go out > on eth1. I pretty much have this same setup. I don't have routing enabled is all. I configure each ethx device like they were on a single network. When your system is up and running, check the routing table, using route. It'll tell you which interface can reach which networks. My setup has 192.168.a.b/24 on eth0, 192.168.c.d/24 on eth1 and I can ping hosts on both networks. There's always a possibility I don't understand your question! :) Thanks! Mark Schoonover IS Manager American Geotechnical V: 858-450-4040 - F: 714-685-3909 - C: 858-472-3816 "Stop the Earth!! I want off!!"