-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
I am running Centos 4.3 with the 2.6.9-42.EL.jwltest.156 kernel (to get
the skge module)
The card is recognized, and I can see traffic when I utlilize wireshark
in promiscuous mode including attempts at responding to ARP requests.
9.608260 DellPcba_b8:d7:63 -> Broadcast ARP Who has 172.20.15.25?
Tell 172.20.15.27
9.608281 D-Link_87:55:06 -> DellPcba_b8:d7:63 ARP 172.20.15.25 is at
00:15:e9:87:55:06
However, no icmp traffic passes, and the pinging host acts as if it
can't find the address. Even after supposedly responding to the ARP
traffic it still shows no TX packets.
ifconfig output:
eth2 Link encap:Ethernet HWaddr 00:15:E9:87:55:06
inet addr:172.20.15.25 Bcast:172.20.15.255
Mask:255.255.255.0
inet6 addr: fe80::215:e9ff:fe87:5506/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:520 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:50348 (49.1 KiB) TX bytes:0 (0.0 b)
Interrupt:11
dmesg | grep eth2 output:
skge eth2: enabling interface
skge eth2: Link is up at 1000 Mbps, full duplex, flow control none
eth2: no IPv6 routers present
device eth2 entered promiscuous mode
device eth2 left promiscuous mode
(promiscuous mode is a result of using tshark)
[root at jupiter2 ~]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref
Use Iface
68.XXX.XXX.0 * 255.255.255.128 U 0 0
0 eth0
172.20.15.0 * 255.255.255.0 U 0 0
0 eth2
default 68.XXX.XXX.XXX 0.0.0.0 UG 0 0
0 eth0
Any suggestions welcome.
Thanks,
David Nalley
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (MingW32)
iD8DBQFE/zY/U7rV35qFz0QRAhp9AJsGpASubdklwHnAmL5YbJHB+OJCcgCgl3Kp
c1/3G1krkmtr47uoNytp5Qo=
=PF4g
-----END PGP SIGNATURE-----