[CentOS] Fujitsu RX200 S3
Camron W. Fox
cwfox at us.fujitsu.com
Thu Aug 30 20:21:21 UTC 2007
Camron W. Fox wrote:
> Alle,
>
> I am trying to install CentOS 5 on a Dual Xeon 5160 FJ RX200 S3. The
> RAID hardware is an internal LSI MPT 1068 SAS/RAID controller (LSI
> 1068SASIME-2300). I have downloaded the drivers (mptsas, mptscsih and
> mptbase) and created the required floppy.
> When I run linux dd after booting from either the DVD or Disk 1 of
> the CentOS distro, it says it loads mptsas, mptbase and mptscsih and
> then comes up with "No drivers of the appropriate type were found",
> etc... Consequently, the RAID device is not found and no disks are
> available for installation.
> When I do this with RHEL5 Disk 1, the drivers load correctly and
> there is no problem.
> I went to the LSI Logic site to download the drivers directly from
> there, but they apparently don't support RHEL5 as of yet for the
> LSISAS1068.
> Any assistance would be greatly appreciated.
>
> Best Regards,
> Camron
>
Alle,
Apparently, I should have just "trusted the process". Doing a regular
install *without* the using the FJ driver disk works just peachy.
Best Regards,
Camron
Camron W. Fox
Hilo Office
High Performance Computing Group
Fujitsu America, INC.
E-mail: cwfox at us.fujitsu.com
More information about the CentOS
mailing list